RAMPS Board is Done!

So the RAMPS Board should now be completely soldered! Here it is completed:

The plan is to have the frame finished by next week! 

It has been a while...

DreamMachine hasn't made much progress over the last week because of other school needs. Yesterday, we made more progress on the frame, and the Ramps board is starting to get soldered. Take a look:

This is the progress from the day before. Keep in mind this board was a completely empty board before we started.

Here is a little shot of Matt soldering in action! Rumor has it that he is a thumb model.

A little more progress on the board. 

More Frame!

Today we worked more on the frame of the printer. We made some more progress on it, and it's coming along pretty great! Take a look:

Back From Spring Break!

After returning from spring break today, we started assembling the printer. We got the two support triangle frames made, and started working on the Y axis. Noticing that we had no fender washers ordered, we decided to stop there and work on some other school work. We will be getting some fender washers tonight to keep progress going on this frame for tomorrow.

Here we have one of the triangle-frame assembled

And the two triangle-frames assembled

And finally part of the Y-axis

A Few More Prints...

We had a busy week this week besides working on the 3D printer, so we didn't get a lot of progress in. But we had 2 days that we printed more parts. Here they are below:

The parts were printed with our ColorFabb "Dutch Orange," and "Lila." We believe we only need one more print, and then all the printable parts will be done! Next week is spring break, so we have a week off of the printer and then we will be working hard on the assembly!